DALI relay contact RM module for controlling via the DALI bus
The DALI relay contact RM module provides a relay contact that can be controlled via the DALI bus and can be used for switching lights and small loads or for controlling contactors. Loads without DALI input can be integrated into the DALI system in this way.
Compact relay module for controlling a standard contactor or load via DALI
Easy integration of loads without DALI input into a DALI circuit; the loads can be switched on and off via DALI commands
Switch-on and switch-off points can be configured using the parameters MIN LEVEL, MAX LEVEL, FADE RATE and FADE TIME
The DALI-Cockpit is a free DALI configuration tool from Lunatone available for configuration download
The DALI RM is supplied via the DALI bus
Loads may only be connected directly to the DALI RM if the inrush current of the load is below 6A. Otherwise a contactor must be connected in between. Alternatively, we recommend using the DALI RM8 (up to 80A inrush current) or DALI RM16 (up to 160A inrush current) modules for high inrush currents.
The maximum load of a contactor coil may be connected to the DALI RM.
When selecting the correct contactor, the inrush current of the contactor must also be observed; this must not exceed 6A
DC contactor coils must be equipped with freewheeling diodes
Dimmable/ControlAvailability to control illumination:DALIDALI - specific lightinginterface. Needs further components like DALI-Controller. Each drivers has its own adress and via BUS-control it provides continously opportunity to dim and switch the light.