LED converter Mini ZLL - interface for wireless dimming
This interface converts a WIRELESS ZLL signal into PWM signals (1) or a 0/1...10 V signal. Dimming is made via PWM or 0-10 V.
By way of the 4 PWM outputs up to 20 LED drivers with SYNC port can be connected by means of a synchronization cable supplied separately (1).
Class II protection against electric shock for direct or indirect contact.
The converter can be powered directly from the mains (100 ¸ 240 VAC) or by a 12 VDC voltage.
By means of the auxiliary output a 12 VDC load can be powered up to 2 W.
against input over voltages from mains;
short circuit and open circuit;
thermal protection = automatic resetting type;
Non-IC; minimum clearance distance from top and lateral sides to normally flammable building element or building insulation = 5 mm. Minimum clearance distance from separate lamp or light source container = 5 mm.
Minimum cut-out diameter: 40mm
Plastic case: IP20 (Independent Use)
lambda max. Power Factor
Mini ZLL Interface
100 ¸ 240
"Open collector" type PWM output.
(1) Compatible ONLY with FULL PWM products.
0/1-10 V port Imax. 10mA.
Reset: perform 3 power on/off cycle of 3-5-7 seconds. At fourth power of the product it performs a flash to confirm the reset.
Setup of the TCI Zigbee devices like this:
Step 1: Hue-App go for "Search Luminaires" Step 2: Switch on TCI Zigbee device Device should be connected within some seconds. Check signal level when close to metal surfaces or inside metal box.
For more information please refer to the data sheet in the Download Tab.
Constant VoltageOutput Voltage is constant, e.G. for operation of LED lamps or LED-Stripes:12V
Dimmable/ControlAvailability to control illumination:1..10VControl input for external voltage from 1-10V or passiv via potentiometer or specific 1-10V device., WirelessDevice is using wireless interface for controlling constant current or voltage., Zigbee, PWMDimmable via PWM input
TOP LED-DALI control unit 60W linear (AM) and PWM dimmable. A new generation of flicker-free led drivers also while dimming. Adjustable currents from 350mA - 1050mA via dip switch. Two versions available AM and PWM dimming