Integration of 0-10V devices in a DALI system with Lunatone DALI 0-10V interface
This interface DALI 0-10V by Lunatone, converts DALI-signals into an analog 0-10V signal. This makes the integration of LED-ballasts or electronic ballasts with 0-10V or 1-10V control input into a DALI-system possible. By choosing a linear or logarithmic dimming curve and either from 0-10V or 1-10V output voltage range, the interface becomes DALI 0-10V IEC62386-206 compliant (DALI Device Type 5).
The following models are available here: Converting a DALI signal into a galvanic isolated PWM signal (up to 1mA output current): 86458508-PWM Converting a DALI signal into a galvanic isolated PWM signal (up to 100mA output current): 86458508-100 Converting a DALI signal into an 0-10V analog signal without galvanic isolation: 86458508-LE Converting a DALI signal into an 0-10V analog signal with galvanic isolation: 86458508-AN
Converting of the DALI 8-Bit Arc-Power-Level in an analog output voltage from 0V to 10V
Manufacturer-specific mode for the adjustment of the output voltage range (from Firmware 2.0)
Particular for devices with 0-10V control input
Output voltage range switchable between 0-10V and 1-10V
Choosing of linear or logarithmic dimming curve (DT5)
The DALI 0-10V has a DALI-adress and can be assigned to groups and scenes
Multiport for DALI
Max. current on the output: 1mA
Module for the converting of DALI signals into an 0-10V analog signal (DALI DT5)
The supply of the module happens directly via DALI-line, there is no additional supply needed.
Supply: via DALI
Typical current consumption DALI: <3 mA
Output: 0-10V (0%-100%) analog voltage 1mA max. (current sink)
Dimensions (L x W x H): 39,7 mm x 28,0 mm x 14,2 mm
Weight: ca. 10g
Temperature: 0 ░C - 45 ░C
Protection type: IP20
Cross-section of the connection wires: 0.5-1.5 mm2
Dimmable/ControlAvailability to control illumination:1..10VControl input for external voltage from 1-10V or passiv via potentiometer or specific 1-10V device., DALIDALI - specific lightinginterface. Needs further components like DALI-Controller. Each drivers has its own adress and via BUS-control it provides continously opportunity to dim and switch the light.