and other loads such as ohmic resistors, inductors and/or other capacities of 10W - 300W.
The universal Lunatone DALI phase dimmer for retrofit light sources is also suited for ohmic, inductive and capacitive loads. The universal dimmer is supplied as a trailing edge dimmer for capacitive loads. After having applied the mains voltage, any connected inductive load is identified by the universal dimmer and switched to leading edge dimming.
Are you looking for a phase dimmer with DALI input for smaller loads? Then select one which can be used for outputs of 3W - 25W.
For example, for dimming 230V LED retrofit lamps via DALI (device type 4, firmware 3.0 and higher).
The minimum dimming level (MIN LEVEL) can be adjusted via DALI.
Conversion of the DALI 8 bit arc power level into the corresponding phase voltage with trailing edge control or leading edge control.
Module to integrate “dimmable” 230V light sources into a DALI circuit.
Double terminals for the simple through-connection of the DALI bus.
The module represents a bus user and can be addressed accordingly.
Designed for loads of 10W up to 300W.
Four different types available.
Modell HS for Top-Hat Rail Mounting
Typical current consumption: 6mA
Power supply: via DALI bus
Number of DALI addresses used: 1
Trailing/leading edge phase angle: 0°- 180°
Mains voltage: 230V at 50Hz
Temperature range: -20 °C - +50 °C
Output load range: 10W - 300W
Assembly: ceiling installation
Dimensions (LxWxH): 120x30x20 mm
Cross-section of connecting wires: 1.5 - 2.5 mm2
Variants with the following specifications are available:
Dimmable/ControlAvailability to control illumination:DALIDALI - specific lightinginterface. Needs further components like DALI-Controller. Each drivers has its own adress and via BUS-control it provides continously opportunity to dim and switch the light., Phase-Cut (Triac)Dimming via phase-cut /Triac-control. For further details please check the datasheet.