The reduction level of light can be changed with a simple programming on the mains or by connecting resistor to the "LEVEL" terminal block.
Bilevel N means that the LED driver is normally in reduction mode and through the control signal go to 100% of light output.
Ideal for stree lighting.
Multicurrent-multivoltage converter- universally applicable.
Flicker ( Output Ripple ) <= 3%
External temperature sensor optional.
The Maxi Jolly US Bilevel is also available as a high-voltage version: Maxi Jolly HV Bilevel
|Dip-SW||Power||Voltage out||Current out||# LED|
|Position 1||25 W||74 V max.||350mA const.||max 20|
|Position 2||35 W||72 V max.||500mA const||max 20|
|Position 3||39 W||72 V max.||550mA const||max 20|
|Position 4||46 W||72 V max.||650mA const||max 20|
|Position 5||50 W||71 V max.||700mA const||max 18|
|Position 6||50 W||66 V max.||750mA const||max 18|
|Position 7||50 W||58 V max.||850mA const||max 16|
|Position 8||50 W||55 V max.||900mA const||max 16|
|Position 9||50 W||48 V max.||1,05 A const||max 14|
|Position 10||50 W||48V constant voltage|
Efficiency depending of the power: 20W - 50W : 84% - 91%
All tci Jolly converter can be connected to each other via sync-cable. Thus, the control over only one button is possible.
Maximum 10 drivers synchronization, is possible command only one driver (1 Master + 9 Slaves).
Button and installation materials are not included in delivery.
For detailed description please refer to the data sheet.
Write the first Review!
Very slim high voltage LED driver 60W, dimmable via DALI, 1..10V and Push; constant currents: 250, 350, 400, 450, 500, 550, 600, 700mA
Low Current LED Driver DALI
constant current source 100mA to 380mA via Dip-switch