LED Converter Mini ZLL

LED converter Mini ZLL - interface for wireless dimming

This interface converts a WIRELESS ZLL signal into PWM signals (1) or a 0/1...10 V signal.
Dimming is made via PWM or 0-10 V.

Features:

• By way of the 4 PWM outputs up to 20 LED drivers with SYNC port can be connected by means of a synchronization cable supplied separately (1).
• Class II protection against electric shock for direct or indirect contact.
• The converter can be powered directly from the mains (100 ÷ 240 VAC) or by a 12 VDC voltage.
• By means of the auxiliary output a 12 VDC load can be powered up to 2 W.
• Protections:
  • against input over voltages from mains;
  • short circuit and open circuit;
  • thermal protection = automatic resetting type;
  • Non-IC; minimum clearance distance from top and lateral sides to normally flammable building element or building insulation = 5 mm. Minimum clearance distance from separate lamp or light source container = 5 mm.
• Minimum cut-out diameter: 40mm
• Plastic case: IP20 (Independent Use)

 

Operation mode:

• "Open collector" type PWM output.
• (1) Compatible ONLY with FULL PWM products.
• 0/1-10 V port Imax. 10mA.
• Reset: perform 3 power on/off cycle of 3-5-7 seconds. At fourth power of the product it performs a flash to confirm the reset.

Setup of the TCI Zigbee devices like this:

Step 1: Hue-App go for "Search Luminaires"
Step 2: Switch on TCI Zigbee device
Device should be connected within some seconds.
Check signal level when close to metal surfaces or inside metal box.

For more information please refer to the data sheet in the Download Tab.
Some hints by LEDclusive.de:
We have successfully tested the TCI-Module with Philips Hue Bridge and got following experience. Just follow the setup procedure above, the device can be easy found in the setup of luminaires.
In case something went wrong, we recommend running the reset procedure. This is described on the label. Take care to follow the time sequences exactly.
We use one metronome for counting. Successful reset get confirmed by a short off and on of the connected LED-module.