Over 15 years of experience in LED technology
Free shipping over 150€ (GER)

Phase control rotary dimmer

Product information "Phase control rotary dimmer"

Phase Control Rotary Dimmer for LED, incandescent and HV halogen lamps

  • Phase angle rotary dimmer/ trailing edge dimmer for powers of 5-100 W/VA or 15-450 W/VA
  • Push-pull switch with soft paster
  • Works absolutely noiseless
  • Electronic short-circuit protection
  • Flicker-free dimming by setting the basic brightness
  • Screw terminals up to 2.5 mm
  • No stand-by loss
  • 230V AC, 50Hz
  • Optionally available with cover frame (pure white - frame width 82 mm, rocker dimension 58.6 x 58.6 mm) and cover for rotary dimmer and potentiometer (pure white - rocker dimension 58.6 x 58.6 mm)


Technical specifications

Article No. 761-852.400 761-852.401
Load type Universal and LED retrofit Universal and LED retrofit
Rated capacity 5-100 W/VA 15-450 W/VA
LED 3 - 35 W 5 - 150 W
Nominal voltage 230 V 230 V
Frequency 50 Hz 50 Hz
Method of operation Rotary / Pushbutton Rotary / Pushbutton
Dimming mode Leading-edge Trailing-edge
Mounting Flush Flush
Method of Mounting Clamping / Screw Clamping / Screw
Protection type IP20 IP20
Dimensions 70x70x35 mm 70x70x35 mm
Diameter shaft 4 mm 4 mm

Setting the basic brightness
In case you recognize flickering in the lower dimming range or a poor switching-on performance while dimming a LED-lamp, you can adjust the minimum brightness in this range in order to eliminate these weaknesses. To adjust the basic brightness, set the actuating button to the left stop (minimum brightness). Now use a screw driver to set the desired basic brightness on the potentiometer. Pursuant to EN 60669-2-1 (8.6.102), the basic value should be set in such a way that the light visibly glows over the entire load range (at rated voltage 10%) when it is set to dark position.

Setting the maximal brightness
Should the light flicker when it is set to maximum brightness, the maximum value for flicker-free operation can be set via the setting option transformer adjustment. To set that value, set the actuating button to the right stop (maximum brightness). Now use a screw driver to set the maximum possible flicker-free brightness on the potentiometer transformer adjustment.

Safety instructions
Works at the 230V mains must only be carried out by a specialist under consideration of the valid regulations (e.g. DIN-VDE). All kinds of work must only be carried out when the mains voltage is disconnected. Non-observance of these installationinstructions may lead to a damaged device, fire or other dangers. If the device is opened or tampered with,the warranty will expire.
The observance of this instruction manual is part of our terms of guarantee.

Installation and operating instructions can be found in the Download tab.
Properties "Phase control rotary dimmer"
·Dimmable/Control: Phase-Cut (Triac)
Manufacturer "OPUS Jaeger Direkt"
Related links of the manufacturer

User manual 3 - 35W

0 of 0 reviews

Leave a review!

Share your experiences with other customers.


Similar Products

Phase section rotary dimmer
For universal loads. Installation flush-mounted for outputs of 20-315 W.
Product number: 762
Covering
+1

€47.95*

delivery time 3-5 Working days*

LED service 4 U

LED-TECHNIK PUR

You can find even more knowledge, experience reports and test series in our
LED knowledge blog
Here we have created many helpful contributions illustriously and informatively.

Satisfied with website information, advice and products?

Then please give us a few stars at Googlegoogle stars